Table of Contents
Advertisement
128
3-2. Opening, closing and locking the doors
■
Effective range (areas within which
the electronic key is detected)
When locking or unlocking the
doors
The system can be operated when the
electronic key is within about 0.7 m (2.3
ft.) of outside front door handle and back
door. (Only the doors detecting the key
can be operated.)
When starting the hybrid system or
changing power switch modes
The system can be operated when the
electronic key is inside the vehicle.
■
Alarms and warning messages
A combination of exterior and interior
buzzers as well as warning messages
shown on the multi-information display
are used to prevent theft of the vehicle
and accidents resulting from erroneous
operation. Take appropriate measures
based on the displayed message.
(P.386)
When only an alarm sounds, circum-
stances and correction procedures are
as follows.
●
Exterior buzzer sounds once for 5
seconds
Situation
An attempt was made
to lock the vehicle while
a door was open.
●
Interior buzzer sounds continuously
COROLLA CROSS HYBRID_Kouzui_GE
COROLLA CROSS HYBRID_OM_General_OM16537E
The power switch was
turned to ACC while the
driver's door was open
(or the driver's door
was opened while the
power switch was in
ACC).
The power switch was
turned to off while the
driver's door was open.
■
Battery-saving function
The battery-saving function will be acti-
vated in order to prevent the electronic
key battery and the 12-volt battery from
being discharged while the vehicle is not
operated for a long time.
●
In the following situations, the smart
entry & start system may take some
time to unlock the doors.
• The electronic key has been left within
approximately 3.5 m (11 ft.) of the out-
side of the vehicle for 2 minutes or
longer.
• The smart entry & start system has
not been used for 5 days or longer.
●
If the smart entry & start system has
not been used for 14 days or longer,
the doors cannot be unlocked from
any door except the driver's door. In
this case, hold the driver's door han-
dle, or use the wireless remote control
or mechanical key to unlock the
doors.
■
Electronic key battery-saving func-
tion
Correction
When battery-saving mode is set, bat-
procedure
tery depletion is minimized by stopping
Close all of
the electronic key from receiving radio
waves.
the doors and
lock the doors
Press
again.
holding
key indicator flashes 4 times.
Correction
Situation
procedure
Turn the
power switch
off and close
the driver's
door.
Close the
driver's door.
twice while pressing and
. Confirm that the electronic
Advertisement
Table of Contents
