Table of Contents
Advertisement
WARNING
●
A non-genuine Toyota suspension
(lowered suspension, etc.) is
installed.
●
Towing eyelets are installed.
●
A backlit license plate is installed.
■
When using Toyota parking
assist-sensor
In the following situations, the system
may not function correctly due to a
sensor malfunction, etc. Have the
vehicle checked by your Toyota
dealer.
●
The Toyota parking assist-sensor
operation display flashes or shows
continuously, and a beep sounds
when no objects are detected.
●
If the area around a sensor collides
with something, or is subjected to
strong impact.
●
If the bumper or grille collides with
something.
●
If the display flashes or is displayed
continuously and a buzzer does not
sound, except when the mute func-
tion has been turned on.
●
If a display error occurs, first check
the sensor.
If the error occurs even when there
is no ice, snow or mud on the sen-
sor, it is likely that the sensor is mal-
functioning.
■
Notes when washing the vehicle
Do not apply intensive bursts of water
or steam to the sensor area.
Doing so may result in the sensor
malfunctioning.
●
When using a high pressure
washer to wash the vehicle, do not
spray the sensors directly, as doing
so may cause a sensor to malfunc-
tion.
COROLLA CROSS HYBRID_Kouzui_GE
COROLLA CROSS HYBRID_OM_General_OM16537E
4-5. Using the driving support systems
●
When using steam to clean the
vehicle, do not direct steam too
close to the sensors as doing so
may cause a sensor to malfunction.
■
The system can be operated when
●
The power switch is in ON.
●
Toyota parking assist-sensor function
is on.
●
The vehicle speed is less than about
10 km/h (6 mph).
●
A shift lever other than P is selected.
■
If "Parking Assist Unavailable" is
displayed on the multi-information
display
●
Water may be continuously flowing
over the sensor surface, such as in a
heavy rain. When the system deter-
mines that it is normal, the system will
return to normal.
●
Initialization may not have been per-
formed after a battery terminal was
disconnected and reconnected. Initial-
ize the system. (P.229) If this mes-
sage continues to be displayed even
after initialization, have the vehicle
inspected by your Toyota dealer.
■
If "Parking Assist Unavailable
Clean Parking Assist Sensor" is
displayed on the multi-information
display
A sensor may be covered with ice,
snow, dirt, etc. Remove the ice, snow,
dirt, etc., from the sensor to return the
system to normal.
Also, due to ice forming on a sensor at
low temperatures, a warning message
may be displayed or the sensor may not
be able to detect an object. Once the ice
melts, the system will return to normal.
■
If a 12-volt battery terminal has
been disconnected and recon-
nected
The system needs to be initialized. To
initialize the system, drive the vehicle
straight ahead for 5 seconds or more at
229
4
Advertisement
Table of Contents
