Table of Contents
Advertisement
396
8-2. Steps to take in an emergency
then turn it off. Check the tire
inflation pressure.
If the tire inflation pressure is
under 130 kPa (1.3 kgf/cm
bar, 19 psi): The puncture can-
not be repaired. Contact your
Toyota dealer.
If the tire inflation pressure is
130 kPa (1.3 kgf/cm
psi) or higher, but less than the
specified air pressure: Proceed
to step 22.
If the tire inflation pressure is the
specified air pressure (P.424):
Proceed to step 23.
22Turn the compressor switch on
to inflate the tire until the speci-
fied air pressure is reached.
Drive for about 5 km (3 miles)
and then perform step 20.
23Attach the air release cap to the
end of the hose.
If the air release cap is not attached,
the sealant may leak and the vehicle
COROLLA CROSS HYBRID_Kouzui_GE
COROLLA CROSS HYBRID_OM_General_OM16537E
may get dirty.
24Store the bottle in the luggage
compartment while it is con-
nected to the compressor.
2
or
25Taking precautions to avoid sud-
den braking, sudden accelera-
tion and sharp turns, drive
carefully at under 80 km/h (50
mph) to the nearest Toyota
2
or bar, 19
dealer that is less than 100 km
(62 miles) away for tire repair or
replacement.
When having the tire repaired or
replaced, make sure to tell the Toyota
dealer that the sealant is injected.
■
If the tire is inflated to more than
the specified air pressure
1
Disconnect the hose from the valve.
2
Install the air release cap to the end
of the hose and push the protrusion
on the air release cap into the tire
valve to let some air out.
3
Disconnect the hose from the valve,
remove the air release cap from the
hose and then reconnect the hose.
Advertisement
Table of Contents
