Setting Curvepoints P0 And P9 For "G Mod Pneu", "Gp1 Mod Pneu" And "Gp2 Mod Pneu - Siemens LMV37.4 Series Basic Documentation

and
F
and
or
To the next curvepoint
To the next curvepoint
27.11.3 Setting curvepoints P0 and P9 for «G mod pneu», «Gp1 mod pneu»
and «Gp2 mod pneu»
Building Technologies
P
A
V h
P
V h
P
V h min s
P
V h min s

Note!
You now have the option of pressing
section Warm settings for modulating operation «G mod», «Gp1 mod», «Gp2 mod»
and «Lo mod») or pressing
Cold settings for «G mod», «Gp1 mod», «Gp2 mod» and «Lo mod») of the
LMV37.4.
Note!

Refer to chapter Setting curvepoints P0 and P9 for modulating operation («G
mod», «Gp1 mod», «Gp2 mod» and «Lo mod»)! Here, only the air requires
adjustment with
Basic documentation LMV37.4...
27 Parameter level
Press simultaneously
or
Example: 20.0
s min %
Release
The selected value is adopted.
Example: 20.0
s min %
Press
P9 appears blinking.
Curvepoint for high-fire.
%
Same procedure as with P0
Note!

If
90!
Press
The display shows run (identification of start
for setting the curve parameters).
%
to proceed with the warm settings (see
/reset
ESC
to proceed with the cold settings (see section
.
A
and
F
A
to adjust speed n0 of the VSD.
and .
F A
.
is pressed first, the display jumps to
Back to the previous
curvepoint
.
and
203/267
CC1P7546en
17.12.2018