Setting Curvepoints P0 And P9 For "G Mod Pneu", "Gp1 Mod Pneu" And "Gp2 Mod Pneu - Siemens LMV27.100x2 Basic Documentation

and
F
and
or
To the next curvepoint
To the next curvepoint
26.11.3 Setting curvepoints P0 and P9 for «G mod pneu», «Gp1 mod pneu»
and «Gp2 mod pneu»
162/219
Building Technologies
P
A
V h
P
V h
P
V h min s
P
V h min s

Note!
You now have the option of pressing
section Warm settings for modulating operation «G mod», «Gp1 mod», «Gp2 mod»
and «Lo mod») or pressing
Cold settings for «G mod», «Gp1 mod», «Gp2 mod» and «Lo mod») of the LMV27.

Note
Refer to chapter Setting curvepoints P0 and P9 for modulating mode («G mod»,
«Gp1 mod», «Gp2 mod» and «Lo mod»)! Here, only the air requires adjustment with
.
A
Basic Documentation LMV27...
26 Parameter level
Press simultaneously
or
controller.
s min %
Example: 20.0
Release
The selected value will be adopted.
Example: 20.0
s min %
Press
P9 appears blinking.
Curvepoint for high-fire.
%
Same procedure as with P0
Note!

If is pressed first, the display jumps to
90!
Press
The display shows run (identification of start
for setting the curve parameters).
%
to proceed with the warm settings (see
/reset
ESC
to proceed with the cold settings (see section
and and
F A
to adjust speed n0 of the load
and .
F A
.
Back to the previous
curvepoint.
.
CC1P7541en
17.12.2018