Table of Contents
Advertisement
Step 20
Tighten the end cap bolts using a 3/8 in (9.5 mm) nut driver. Tighten evenly until the
endplate cap is fully sealed.
Figure 58. Securing the end cap bolts (left), the caps completely secure (right)
CAUTION: Do not use power tools to tighten bolts as this can damage the end caps and
enclosure lid.
Step 21
Apply silicone grease evenly around all outer edges of the cover gasket.
Page 50
Figure 59. Silicone grease around outer edges of the cover gasket
Confidential – Limited Distribution
Advertisement
Table of Contents
Troubleshooting
