Step 3; Step 4 - Optex Fiber SenSys Terrain Defender TD 100 Installation Manual

Step 3

The cable is cut in the middle of the SUMA location to create two cable ends. A coaxial
cable cutter should be used.
Rotate the tool around the sensor cable as you apply pressure. It only requires a small
amount of pressure to cut through the jackets, the outer conductor, and the heavy copper-
clad aluminum center conductor. Once the cutter's blade contacts the center conductor,
score the outside of the center conductor. Remove the cutter, grab the sensor cable from
both sides of the cut, and bend until it breaks in two leaving a clean square cut.

Step 4

Page 38
Figure 34. SUMA tab removal
Figure 35. Coaxial Cable Cutter
Figure 36. Cutting the sensor cable
Confidential – Limited Distribution