Table of Contents
Advertisement
the total lengths at 60 mm (2.36 in) of braided drain wire and a 30 mm (1.18 in) center
conductor. Split the drain wire into two halves, as seen in
Figure
49.
Insert the center conductor into the large terminal block on the cable splice assembly and
clamp it shut. Insert and clamp the drain wire halves to each of the smaller terminal blocks
on each side of the center conductor terminal block. Repeat the process on the other half of
the cable splice assembly.
Figure 84. TDSC Repair Kit with cable preparation complete
Apply silicone grease to the grommets and reinsert them in the cable ports. Apply silicone
grease evenly around all outer edges of the cover and enclosure base gasket. Seat the
cover on top of the enclosure body and tighten all bolts using a 3/8 in (9.5 mm) nut driver.
Bury the assembled repair kit enclosure and test the sensor cable.
Confidential – Limited Distribution
Page 76
Advertisement
Table of Contents
Troubleshooting
