Optex Fiber SenSys Terrain Defender TD 100 Installation Manual page 18

Voltage drops as power passes down the Terrain Defender Sensor Cable (TDSC)
TD24PSU can power up to 3 units
TD24PSU
or
TD48PSU
TD100 TD100
Lead Middle
400 m TDSC
Two or more power supply units are required for power redundancy.
The Lead Processor typically connects to the Master Controller via Ethernet cable. For
redundant operation, the End Processor can also connect to the same or a separate Master
Controller.
During installation, connect a computer to a TD100 processor via the RJ-45 connector using a
standard Ethernet cable and enter the TD100 default IP address 192.168.0.1. Enter username:
Admin password: Admin to connect to the Web User Interface (WUI). While the WUI has some
of the same displays as the Master Controller, it is more focused on setting up a processor.
TD100 Default Password Table:
System Level
User 1
User 2
Administrator
Please see the Web User Interface (WUI) Manual for more information on the TD100 user
interface, such as cable calibration, tuning for intrusion detection, and relay setup.
Page 18
from each TD100
TD100
Middle (48VDC)
End (24VDC)
400 m TDSC 400 m TDSC
Figure 13. System power with single TD24PSU or TD48PSU
Username
oper
oper2
admin
TD48PSU can power up to 6 units
TD100 TD100
Middle Middle
400 m TDSC
Password
oper
oper2
admin
Confidential – Limited Distribution
TD100
End
400 m TDSC