Manual Control Menu; Fixture And Iq.mesh Information; Service; Loading Factory Backup - GLP Creative Light 1 User Manual

Manual Control menu

The Manual Control menu lets you use the control panel on the front of the CL1 to
display a static scene or run a dynamic pattern over the top of the main color. See
full details under 'Manual control' on page 20.

Fixture and iQ.Mesh information

The Information menu lets you call up information about the CL1's fixture software
(firmware) versions and operating data. It also lets you call up information about the
iQ.Mesh system and see the fixture's current iQ.Mesh status.

Service

The Service menu gives three options for managing the CL1's firmware and settings.
• iQ.Mesh Upload prepares the CL1 for a firmware upload over an iQ.Mesh network
using the GLP Creative Light smartphone app. See the section on 'Uploading new
firmware' on page 33 for details.
• Load Setting Defaults is identical to the Default Settings command in the Fixture
Settings menu. It returns the CL1 to its factory default settings without affecting its
control configuration. Mic Sensitivity, No-Signal Behavior etc. are returned to their
factory default settings, but DMX Address, Signal Source and Control Mode are
not changed. The CL1's default settings are printed in bold type in the control
menus table starting on page 36.
• Load Factory Backup re-initializes the CL1 completely. It returns the CL1 to its
factory default settings including its factory-set control configuration. Mic
Sensitivity, No-Signal Behavior etc. DMX Address, Signal Source and Control Mode
are all returned to the original factory default settings. The CL1's default settings
are printed in bold type in the control menus table starting on page 36.
Important! A Load Factory Backup command will reset the CL1 to Manual / IR
Remote control. Any link to CRMX or iQ.Mesh control will be cut off.

Loading factory backup

To re-initialize the CL1 and restore its original factory
settings, switch the fixture on, then use a shortcut by
holding the ENTER button pressed in for 6 seconds.
The CL1's individual configuration with all custom
settings is returned to factory defaults.
Important! If you are using CRMX (CL1+ only) or
iQ.Mesh control, note that loading factory backup
returns the fixture to an unlinked state, breaking off
communication with the CRMX link or iQ.Mesh
network.
CL1 / CL1+ User Manual
Figure 7. Restoring factory
18
www.glp.de
settings