Control Menus - GLP Creative Light 1 User Manual

13. Control menus

This chapter gives the contents of the menus in the control panel on the front of the
CL1.
The menu items marked in yellow are available in the CL1+ only.
DMX Address
1-512
Control Mode
M1 - RGB
M2 - Pattern
M3 - MultiPix
Signal Settings
CRMX
iQ.Mesh
Signal source
Manual / IR Remote
CRMX
Unlinked / Linked
Link/Unlink
iQ.Mesh
Unlinked / Linked
Link/Unlink
IR Remote
control On / Off
On/Off
Fixture Settings
Blackout
No-signal
Hold last value
behavior
Manual Control
Mic sensitivity 01 ... 05 ... 10
CL1 / CL1+ User Manual
Set fixture's DMX address
All LED pixels controlled together.
Controllable color and intensity plus
shutter/intensity effects and a
Control/Settings channel.
Global intensity and shutter control. Color
control of all LED pixels together in base
layer.
Top layer (Layer 2) with patterns can be
superimposed onto base layer.
Global intensity and shutter control.
Individual color control of each LED pixel.
Only CRMX signal is active, all other control
signal sources are ignored
Only iQ.Mesh signal is active, all other
control signal sources are ignored
Fixture controlled by its own control buttons
and display or by infrared remote if IR
Remote is enabled (see below)
Shows current CRMX linking status. Press
ENTER to unlink (confirm 3s)
Shows current iQ.Mesh linking status. Press
ENTER to unlink (confirm 3s)
Fixture responds to / ignores signal from
infrared remote
If no control signal present, fixture blacks
out
If no control signal present, fixture continues
to use last valid control signal received
If no control signal present, fixture goes into
manual control mode
Adjust sensitivity of audio triggering
microphone, low ( 01) to high (10) sensitivity
36
www.glp.de