Cleaning And Product Care; Suggested Cleaning Intervals; Checking Firmware Version; Uploading New Firmware - GLP Creative Light 1 User Manual

German Light Products®

12. Cleaning and product care

Warning! There are no user-serviceable parts inside the CL1. Do not
attempt to open the CL1 or you may void the product warranty. Do not
use water or any other liquid for cleaning.

Suggested cleaning intervals

The CL1 requires occasional cleaning to prevent the buildup of dust and dirt. The
cleaning schedule depends on the operating environment.
Pay special attention to the LEDs, control panel display and IR remote control sensor
(see 'Product overview' on page 9). Failure to keep the LEDs clean will significantly
reduce light output and may cause damage. Regular cleaning will ensure maximum
performance and reliable operation.
Use a soft, dry cloth only for cleaning. Do not use solvents or abrasive products of
any kind. Apply only gentle pressure to the LEDs.

Checking firmware version

We recommend that you always have the latest firmware installed. Firmware, user
documentation and other information about GLP products are available from the
GLP website at www.glp.de.
You can check the CL1's firmware in the top right-hand corner of the CL1's
integrated display. For details of the CL1's internal drivers, open the control menus
and then scroll to and open the INFORMATION menu.

Uploading new firmware

The easiest way to upload new firmware to a CL1 is to use the Creative Light app to
send the firmware over an iQ.Mesh Network.
It is also possible to upload new firmware using the optional DPROG firmware
uploader hardware from GLP and a DMX-to-USB-C adapter. Contact your GLP
supplier for more information.
Uploading with DProg
If you wish to upload firmware using GLP's DProg system, you will need the CL1
firmware package (software and change log file), a DMX to USB-C adapter cable
and a D3-Prog uploader device from GLP.
To update the CL1's firmware using a D3-Prog device:
Upload the required firmware version to the D3-Prog device.
Connect the D3-Prog device to the CL1 using the DMX to USB-C adapter cable.
Switch on the CL1.
Select the CL1 firmware file in the D3-Prog device.
33 Rev. 20210303-01