Dmx; Output To X4 Atom Head; The Menu Field - GLP X4 atom PSU 12 Instruction Manual

4.2 DMX

USITT DMX-512 Standard input/output in XLR 5-pin connectors.
Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4 & 5 N.C.
The DMX- Addressing starts at the DMX- Address [001].

4.3 Output to X4 ATOM Head

12 x 4-pin XLR connectors for signal and power to Atom Head only.
Pin 1 = [Ground] / Pin 2 = [Data +] / Pin 3 = [Data -] / Pin 4 = [V+ 24V]
Do not exceed 60m / 200ft. cable length for any output to the X4 ATOM
head.
Attention: Do only connect one (1) GLP X4 ATOM head per output. Never
connect any other equipment to this output as this may damage the PSU
and/or the connected fixture(s).

5 The Menu Field

You'll find the control board on the front side of the X4 ATOM
PSU 12.
It allows you to make all necessary adjustments of the fixture.
With the Mode-key you get into the main menu. Afterwards you
can Navigate through the menu with the Up/Down-keys. Push
the Enter-key to get in the next menu level or to confirm your
settings. Make them and set functions ON/OFF with the
Up/Down-keys. Confirm and save it with the Enter-key (the
display shows OK). Push the Mode-key to cancel the entry and
go back to the main menu.
ß MODE - ENTER à
Level1 Level 2
DMX Start
Address 001
Manual
Special
DMX
X4 Atom PSU12 manual (v1.0)
Level 3 Level 4
Master
Intensity
from software version: v1.21
GLP German Light Products
Remark
Set the DMX start address
Manual control of all fixture functions
Manual control for Master Intensity
8