GLP Creative Light 1 User Manual page 25

German Light Products®
Navigate to SIGNAL SETTINGS → SIGNAL SOURCE and select iQ.Mesh. You can
also use a shortcut by pressing and holding the DOWN Button to change the
control signal source. When the CL1 is set to SIGNAL SOURCE → iQ.Mesh, it will
show a red rotating pixel to indicate that the fixture is not connected to an
iQ.Mesh Network and is ready for linking.
Open the Creative Light app. See Figure 10. Tap on
the Setup and Configuration button (arrowed) in the
top right-hand corner of the main screen to open the
Setup and Configuration screen.
See Figure 11. In the LINKING
section at the bottom of the
Setup and Configuration screen,
tap on the Discovered Unlinked
Devices button (arrowed). The
app will search for unlinked
devices. Each time it discovers a
device it will add it to the list of discovered unlinked devices in the center of the
screen.
You can now either add all the fixtures in the installation or
add single fixtures to the network:
• To add all the fixtures, see Figure 12. Tap on the Link all
discovered devices button.
• To add single fixtures, look down the list of discovered,
unlinked devices in the center of the screen and tap on
the CL1 that you want to add to the network. Then tap
on the Link Selected Fixture button (see Figure 13) on
the right of the screen.
As soon as a CL1 fixture is linked to the iQ.Mesh network, it
changes from showing a red rotating pixel to a green
rotating pixel and the indicator light (top left in Figure 12) turns
from red to green.
You can now control the CL1 using the Creative Light app.
Using the app is intuitive. You will also find tutorials in the app that will
help you learn how to use the app's features.
Figure 11. Discovered Unlinked Devices
25
Figure 10. Setup and
Configuration
Figure 12. Link All
Discovered Devices
Figure 13.
Link Selected
Fixture
Rev. 20210303-01