Connections; Power Supply; Dmx; The Menu Field - GLP impression spot one Instruction Manual

2.3 Connections

2.3.1 Power Supply

Autosensing ~100-240 Volt AC, 50-60 Hz, earth contact type plug via
Powercon
Connected load 450 VA (W) <=> T8A (micro-fuse 6.3x32mm)
Disconnect from the mains supply before changing the fuse and
use only the above described micro-fuse type.

2.3.2 DMX

USITT DMX-512 Standard input/output via 3 pin and 5 pin connectors.
3 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
5 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4/5 n.c.
Ethernet (Artnet II compatible, ACN ready)
Neutrik RJ-45 plug (for Neutrik EtherCon connector with body)

3 The Menu Field

You'll find the control board on the side of the arm. It allows you to make all necessary
adjustments of the I M
I
Afterwards you can navigate through the menu with the Touchwheel. Push the Enter-key to
get to the next menu level or to confirm your settings. Select ON/ OFF function settings with
the Touchwheel. Confirm and save with the Enter-key. Push the Back-key to cancel the
entry and go back to the main menu.
Back - Enter
Layer 1 Layer 2
DMX Start
Address
Personality Pan/Tilt
DMX
GLP German Light Products GmbH
(Instruction version 1.93) / from software version 1.52
P R E S S I O N S p o t O
M P R E S S I O N S p o t
Layer 3
Pan invert
Tilt invert
Feedback
Address
n e . With the Menu-key you get into the main menu.
O n e .
Layer 4 Notes
Set the DMX start address
Pan/Tilt settings
Selects Inverse Pan, on or off
Selects Inverse Tilt, on or off
Automatic position feedback selection for
pan/tilt movement
Set the DMX start address
9