Table of Contents
Advertisement
Information
SW Version
BL Version
Device
HW Version
Information
Lamp Hours
Charging Cycles
iQ.Mesh Version
iQ.Mesh
Information
iQ.Mesh Status Info
Service
iQ.Mesh
Upload
Load Setting
Confirm 3 sec.
Defaults
Load Factory
Confirm 3 sec.
Backup
CL1 / CL1+ User Manual
Fixture software (firmware) version
Bootloader version
Fixture hardware version
Number of hours LEDs are powered on
Number of battery charging cycles
iQ.Mesh firmware version
iQ.Mesh system status
Sets up the fixture to receive manual
upload of iQ.Mesh module firmware.
Returns individual fixture settings and
manual control settings to default values
(bold settings) so that all fixtures behave
identically.
Signal configuration is not changed: this
command does not affect DMX Address,
Signal Source, Control Mode, etc.
Connection to controller will not be lost.
Returns individual fixture settings, manual
control settings and all signal configuration
settings to default values (bold settings) so
that all fixtures behave identically.
Important: this command affects DMX
Address, Signal Source, Control Mode, etc.
Connection to controller will be lost.
38
www.glp.de
Advertisement
Table of Contents
