Connections; Power Supply; Dmx; The Menu Field - GLP impression X4 Instruction Manual

2.4 Connections

2.4.1 Power Supply

~100-240 Volt AC, 50-60 Hz, earth contact type plug - Powercon
Connected load 350 VA (W) <=> T5A (micro-fuse 5x20mm)
Please see printing on the case for the right electronic supply!
Disconnect from the mains supply for changing the fuse and use
only the above described micro-fuse type.

2.4.2 DMX

USITT DMX-512 Standard input/output in 5 pin connectors.
Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4&5 N.C.
The DMX- Addressing starts at the DMX- Address [001].

3 The Menu Field

You'll find the control board on the side part of the arm. It allows you
to make all necessary adjustments of the
Mode-key you get into the main menu. Afterwards you can navigate
through the menu with the Up/Down-keys. Push the Enter-key to get
in the next menu level or to confirm your settings. Make them and set
functions ON/OFF with the Up/Down-keys. Confirm and save it with
the Enter-key (the display shows OK). Push the Mode-key to cancel
the entry and go back to the main menu.
To lock or unlock the keys of the menu field press Mode+Enter+Up simultaneously.
MODE - ENTER
Level1 Level 2
DMX Start
Address 001
Special Manual DMX
GLP German Light Products GmbH
I M P R E
I M P R E
Level 3 Level 4
Pan
Pattern
Byte 3
Pattern
Byte 2
Pattern
Byte 1
Pattern
Zoom
Speed
Movements
(Instruction version: 1.0) / from software version: 1.18/18/12/10/n
S S I O N X 4 . With the
S S I O N X 4 .
Remark
Set the DMX start address
Manual control of all fixture functions
Manual control for Pan (X-movement)
Manual control for Pattern Byte 3 LED 17 -19
Manual control for Pattern Byte 2 LED 9 - 16
Manual control for Pattern Byte 1 LED 1 - 8
Manual control for Pattern channel / bank
Manual control for Zoom
Manual control for Pan/Tilt movements
M o d e D o w n
E n t e r U p
10