Electrical Safety; Installation Safety And Protection From Personal Injury - GLP Creative Light 1 User Manual

Electrical safety

• The product is for indoor use in dry locations only. Do not allow the product to
become wet.
• Disconnect the product from its charger before cleaning. Clean the product with
a soft, dry cloth only. Do not clean with solvents or abrasive products.
• Ensure that any equipment used to charge the product is electrically connected
to ground (earth).
• Disconnect equipment used to charge the product from power if the charging
equipment, power plug, power cable, any cover or any other component is
damaged, defective or deformed. Do not reapply power until the product has
been repaired and made safe by a technician authorized by GLP.

Installation safety and protection from personal injury

• Do not stare directly into the light output at close range. Looking into the light
output at close range may cause eye injury or irritation.
• Install the product in a dry, dust-free location where it will not be exposed to high
temperatures or direct sunlight.
• Ensure that the product is safely supported and cannot fall. If mounting the
product on a wall or other vertical surface or structure, use fasteners that are
suitable for the surface and strong enough to safely hold the weight of the
product.
• The product's integrated magnet may be used for temporary installation on
magnetic surfaces.
• In permanent installations, fasten the product to a surface or structure with screws
fastened into the threaded holes provided on the product or secure the product
against falling by adding an approved safety attachment as directed in this
manual.
• Fasten the product to a structure or surface only as directed in this manual.
• If there is any risk that the product may cause injury or damage if it falls, secure it
with an approved secondary attachment as described in this manual.
• The product can become hot during normal operation. Take precautions to
prevent accidental physical contact with the product. Allow to cool before
handling.
CL1 / CL1+ User Manual
6
www.glp.de