Control Panel Functions - GLP Creative Light 1 User Manual

Control panel functions

The CL1's four control buttons have the following functions:
+
CL1 / CL1+ User Manual
MENU button
Press and hold for 3 seconds: switch CL1 on and off.
•
Press once briefly: open the control menus for manual
•
control or configuration.
If you are in one of the control menus, press once briefly to
•
exit the current menu without making any changes.
If the top-level control menu is active, press and hold for
•
20 seconds to carry out a hard reset. This will disconnect
the battery from the controller for a few seconds while it
fully restarts the CL1.
UP and DOWN buttons
Scroll up and down through menus.
•
If the display is activated and you see the main screen,
•
press and hold the DOWN button for 3 seconds to change
the signal source
ENTER button
If you are in the control menus, confirm a selection or save
•
a change.
If the top-level control menu is active, press and hold for 6
•
seconds to re-initialize the CL1 and return it to its original
factory settings. All custom settings and control
configuration settings will be deleted.
NB: Re-initializing will return the DMX address to 001 and
unlink the CL1 from any existing CRMX or iQ.Mesh link, so
you may lose the connection to your controller.
MENU and ENTER buttons together
If the top-level control menu is active, pressing and
•
holding the MENU button and the ENTER button together
for 6 seconds applies the transport lock and disables all
the control buttons. We recommend that you apply the
transport lock to avoid accidentally powering the CL1 on
during transport or long-term storage.
To unlock the CL1, connect it to a charger.
12
www.glp.de