Linking To A Crmx Transmitter (Cl1+ Only); Dmx Settings (Cl1+ Only); Setting Up Iq.mesh Control - GLP Creative Light 1 User Manual

German Light Products®
In the CL1+, the DMX address also returns to the factory default, which is 001.
To re-establish CRMX control, see below.
To re-establish iQ.Mesh control, see 'Setting up iQ.Mesh control' on page 19.

Linking to a CRMX Transmitter (CL1+ only)

Whenever CRMX is enabled and the CL1+ is not already linked, it searches for a
LumenRadio CRMX transmitter.
To link the CL1+ with a new CRMX transmitter:
Enter the control menus, navigate to SIGNAL SETTINGS → SIGNAL SOURCE and
select CRMX.
Navigate to SIGNAL SETTINGS → CRMX LINK and select LINK/UNLINK.
Start the linking process at the CRMX transmitter as described in the transmitter's
user manual.
TIP: The quickest way of setting up multiple CL1+ fixtures for DMX use is to carry out a
LOAD FACTORY BACKUP on each fixture by pressing and holding its ENTER Button for
6 seconds. This will return the fixture to factory settings and delete all CRMX and
iQ.Mesh links. The fixtures are now ready for linking to a transmitter. After successful
linking, set up the fixtures' DMX addresses and DMX control mode.

DMX settings (CL1+ only)

When using DMX control via CRMX, you need to consider the following setup
options.
DMX Address
If you want individual control of the CL1+ in an installation containing more than one
fixture, you will need to give the CL1+ its own individual DMX address. Fixtures of the
same type that share the same DMX address behave identically.
The CL1+ is set to DMX address 001 by default.
DMX Modes
The CL1 has three DMX control modes: Basic, Pattern and MultiPix modes. The
different modes give you a choice of control options. See 'DMX control modes
overview (CL1+ only)' starting on page 39 for details.

Setting up iQ.Mesh control

To set up a CL1 fixture so that you can control it with the GLP iQ.Mesh system and
Creative Light smartphone app, open the control menus, navigate to SIGNAL
SETTINGS → SIGNAL SOURCE and select iQ.Mesh. See full details under 'Creative Light
app control' on page 24.
19 Rev. 20210303-01