Table of Contents
Advertisement
2.3.3 DMX
USITT DMX-512 Standard input/output in 3 & 5 pin connectors.
3 pin: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
5 pin: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+] / Pin 4/5 n.c.
The DMX- Addressing starts at the DMX- Address [001].
The Menu Field
3
You'll find the illuminated control board on the upper side of
the base. It allows you to make all necessary adjustments
of the system.
The current DMX address will be shown on the top level of
the menu. Use the Enter-key to adjust the DMX address or
press the Menu-key to reach the next level of the menu
where other settings can be made.
With the Enter-key you reach the main menu. Afterwards
you can navigate through the menu with the Up/Down-
keys. Push the Enter-key to get in the next menu level or
to confirm your settings. Adjust them and set functions
ON/OFF with the Up/Down-keys. Confirm and save it with
the Enter-key (the display shows OK).
Use the Back-key to cancel the entry and to go back to the
main menu.
Level1
Level 2
DMX Start
Address
Special
Manual DMX
GLP
German Light Products GmbH
BACK - ENTER
Level 3
Pan
Iris
Focus
Gobo2
Rot Gobo 1
Gobo 1
P/T Speed
P/T
Movement
Level 4
Remark
Define the DMX start address
Manual control of all system functions
Manual control for Pan (X-movement)
Manual control for the Iris
Manual control for the Focus
Manual control for the Gobo 2
Manual control for the rotation of Gobo
1
Manual control for the Gobo 1
Manual control for Pan/Tilt Speed
Manual control for Pan/Tilt Movement
(Instruction version 1.01) / from software version 1.07
M X S t a r t A d d r e s s
1
e n u
E n t e r
V O L K S L I C H T M e n ü
R e s e t
D M X S t a r t A d d r e s s
S p e c i a l
a c k
U P
D o w n
E n t e r
9
Advertisement
Table of Contents
