Control Character Output; Keyboard Modifiers - Honeywell HH1800 User Manual

Control Character Output

This selection sends a text string instead of a control character. For example, when the control
character for a carriage return is expected, the output would display [CR] instead of the ASCII
code of 0D. Refer to
through 1F are converted (the first column of the chart). Default = Off.
Note: Control + X (Control + ASCII) Mode overrides this mode.

Keyboard Modifiers

This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo Mode.
Control + X (Control + ASCII) Mode On: The scanner sends key combinations for ASCII control
characters for values 00-1F. Windows is the preferred mode. All keyboard country codes are
supported. DOS mode is a legacy mode, and it does not support all keyboard country codes.
New users should use the Windows mode. Refer to
page 207 for CTRL+ X Values.
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII control
characters for values 00-1F, but it does not translate prefix or suffix information.
Support ALT 3 Digit HEX Mode: The scanner sends key combinations for ASCII control
characters for values 00-1F transmitted as the ALT key and 3 digits.
Default = Control + X Mode Off.
Windows Mode Control + X Mode On
HH1800 User Guide
Convert All Characters to
Lower Case
ASCII Conversion Chart (Code Page 1252)
Control Character Output On
Convert All Characters to Upper
on page 207. Only codes 00
* Control Character Output Off
ASCII Conversion Chart (Code Page
Case
1252),
17