Control Character Output; Keyboard Modifiers - Honeywell Virtuos 1D User Manual

Control Character Output

This selection sends a text string instead of a control character. For example, when the control character for a carriage return is
expected, the output would display [CR] instead of the ASCII code of 0D. Refer to
1252) on page A-3. Only codes 00 through 1F are converted (the first column of the chart).
Note: Control + X (Control + ASCII) Mode overrides this mode.
Default = Off.
Control Character Output On

Keyboard Modifiers

This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo Mode.
Control + X (Control + ASCII) Mode On: The scan engine sends key combinations for ASCII control characters for values 00-
1F. Windows is the preferred mode. All keyboard country codes are supported. DOS mode is a legacy mode, and it does not
support all keyboard country codes. New users should use the Windows mode. Refer to
1252), page A-3 for CTRL+ X Values.
Windows Mode Prefix/Suffix Off: The scan engine sends key combinations for ASCII control characters for values 00-1F, but
it does not translate any prefix or suffix information.
Default = Control + X Mode Off.
Windows Mode Control + X
Mode On
DOS Mode Control + X Mode On
Turbo Mode: The scan engine sends characters to a terminal faster. If the terminal drops characters, do not use Turbo Mode.
Default = Off
Turbo Mode On
ASCII Conversion Chart (Code Page
* Control Character Output Off
ASCII Conversion Chart (Code Page
* Control + X Mode Off
Windows Mode Prefix/Suffix Off
2 - 15