Control Character Output; Keyboard Modifiers - Honeywell Xenon XP 195 Series User Manual

Control Character Output

This selection sends a text string instead of a control character. For example, when
the control character for a carriage return is expected, the output would display
[CR] instead of the ASCII code of 0D. Refer to
1252)
the chart). Default = Off.
Note: Control + X (Control + ASCII) Mode overrides this mode.
Control Character Output On

Keyboard Modifiers

This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo
Mode.
Control + X (Control + ASCII) Mode On: The scanner sends key combinations for
ASCII control characters for values 00-1F. Windows is the preferred mode. All
keyboard country codes are supported. DOS mode is a legacy mode, and it does
not support all keyboard country codes. New users should use the Windows mode.
Refer to
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII
control characters for values 00-1F, but it does not translate prefix or suffix
information.
Support ALT 3 Digit HEX Mode: The scanner sends key combinations for ASCII
control characters for values 00-1F transmitted as the ALT key and 3 digits.
32
Convert All Characters
to Lower Case
on page 300. Only codes 00 through 1F are converted (the first column of
ASCII Conversion Chart (Code Page
Convert All Characters
ASCII Conversion Chart (Code Page
* Control Character Output Off
1252), page 300 for CTRL+ X Values.
Xenon XP User Guide
to Upper Case