Kyocera TASKalfa Pro 15000c Installation Manual page 364

Machine transportation after setup > Procedure for the main unit transportation (Truck transportation)
IMPORTANT
In case if it is difficult to remove the screw, remove the screw [C] by sliding it to the aperture while slightly lifting
the front [A] or rear [B] of the image conveying belt unit. (screw x4)
[A]
12
Remove the image conveying unit [A] holding handles [B] and [C], and place it on a
table.
• Be careful not to damage the electrical components.
[B]
[A]
IMPORTANT
Pay attention when handling the print conveying belt unit, the lift wire might come off if lifting up the lift plate
from the bottom.
13
Remove the right side bracket [B] from the image conveying unit [A]. (Screw x7)
View after removing image conveying belt unit
[B]
* Screw sliding direction
[C]
[C]
6-34
[CONFIDENTIAL]
[C]
[C]
[C]
[C]