Kyocera TASKalfa Pro 15000c Installation Manual page 140

Enhancement device setup procedure > Optional device installation
Exit Motor Unit
NOTE
• The bind shown in red circle in the harness [A] has to be above the edge saddle [B].
59
Connect the cooling fan harness [A] and communication harness [B] to the main
board of the paper feeder (connector x2). Route the cooling fan harness and
communication harness as shown below. Then connect the connector of the cooling
fan harness to the cooling fan, and insert the connector of the communication
harness into the relay connector in the frame (connector x1).
3-62
[CONFIDENTIAL]