Kyocera TASKalfa Pro 15000c Installation Manual page 338

Machine transportation after setup > Procedure for the main unit transportation (floor to floor)
4
Check a leveler on the main frame and adjust the horizontal level by rotating the level
bolts with 19 mm wrench.
Adjust them as all casters slightly up from floor at the end.
Make sure to adjust the above because the main unit might move if the casters are not up slightly when clearing
the jam by moving the enhancement devices and locate it back to the original position due to pushing the main
unit by the enhancement devices.
5
Attach the front width guide [C] to the front guide bracket [A]. (Screw x1)
6
Attach the rear width guide [D] to the front guide bracket [B]. (Screw x1)
6-8
[CONFIDENTIAL]