Kyocera TASKalfa Pro 15000c Installation Manual page 243

Enhancement device setup procedure > Optional device installation
<H> 5000 Sheet Stacker (ST-9100) to 5000 Sheet Stacker (ST-9100)
NOTE
• Up to two stackers can be docked.
• In this manual, ST-9100 that is closer to main unit, is defined as 1st or upstream unit and further from main
unit is 2nd or downstream unit.
• See 5000 Sheet Stacker (ST-9100)
CAUTION
• The unit must be connected to a power source that is close to the unit and easily accessible.
• Before performing the following procedure, make sure that the main power switch and AC power switch of
the main unit are turned OFF and that the power cord is disconnected. Performing the procedure with the
power on could result in an electric shock or could cause a malfunction.
• Rated voltage of output connector for accessory [A]: Max. DC24V.
IMPORTANT
• Make sure that no cables are sticking out on the floor inside the high capacity stacker.
• Install the high capacity stacker on a flat and level surface. This is to prevent problems during lifting and
lowering operation of the paper tray.
• Do not move the high capacity stacker while the tray cart is installed inside the high capacity stacker.
for unpacking.
3-165
[CONFIDENTIAL]