Kyocera TASKalfa Pro 15000c Installation Manual page 353

Machine transportation after setup > Procedure for the main unit transportation (Truck transportation)
37
Attach the left side bracket [B]. (Screw x8)
38
Attach the right side bracket [B] onto the image conveying unit [A]. (Screw x7)
39
Hold the handles [B] and [C] then re-install the image conveying unit [A].
• Be careful not to damage the electrical components.
[B]
[A]
IMPORTANT
4 pins [C] on rails have to align with 4 holes [A] and [B] in frame of image conveying unit. (Pay attention the
alignment otherwise the unit may drop.)
And also, if the frame goes over the pin, the unit becomes incline and service call error C2700 occurs. Make
sure to check the pin position again.
[B]
[C]
6-23
[CONFIDENTIAL]
[A]
[C]