Performing A Function Test Of The Can-Can-Bluetooth Bridge - PROEMION CANlink wireless 3000 Series Device Manual

4.4.2

Performing a function test of the CAN-CAN-Bluetooth Bridge

It is advisable to perform a function test before using the device. In order to do so, you can
simulate the CAN bus with the aid of a communication gateway (e.g. CANview USB) and read it
out with RM CAN-Device Monitor.
NOTICE
In this section, a function test with the aid of two CANview USB is described. However,
you can also perform the test with comparable communication gateways. If third party
software is used, equivalent steps to create a test transmit-message must be performed.
1. Connect the CANview USB to the PC with a USB cable.
2. Connect the
3. Connect the CANlink wireless with the
4. Connect the low-voltage coupling 1.3/3.5 of the
5. Repeat this procedure for the second CANlink wireless.
Connecting two CANlink wireless 3002 with two CANview USBs to the PC
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0
Device Manual
CAN bus termination D-Sub/D-Sub CANterm 120
D-Sub Connector of the CANview USB.
15 ON to the CANview USB.
terminal 15 ON to the country-specific power supply unit from the starter kit.
CANlink wireless
Getting started
with the 9-pin Male
CAN cable M12 5-pin/D-Sub/Power terminal
CAN cable M12 5-pin/D-Sub/Power
61