PROEMION CANlink wireless 3000 Series Device Manual page 88

NOTICE
The following step is only necessary if you have not allocated a fixed IP address to the
CANlink wireless.
17. Leave the device powered on. Open the DHCP clients table of the WLAN router and
note the IP address of the corresponding CANlink wireless. The IP address is required
for the configuration of the master.
NOTICE
Enter the router's IP address into the browser of the PC in order to access the router
parameters. Navigate to the DHCP overview.
Follow the instructions in the router manual.
 The configuration of the slave device is completed.
CONFIGURATION OF THE CAN-CAN-WLAN BRIDGE MASTER
1. Connect the device to the PC. See chapter Connecting the device with a PC via
RS232.
2. Choose D
 This loads the installed configuration from the device.
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0
Device Manual
→ R
EVICE EAD DATA FROM THE DEVICE
CANlink wireless
Getting started
from the menu.
83