PROEMION CANlink wireless 3000 Series Device Manual page 99

DEVICE TAB
In the list in the C
D B
EFINED AUDRATE
B field.
AUDRATE
NOTICE
To find the correct values for a specific baud rate, contact the Support.
In the F
EEDBACK
function.
Parameter
F CAN
EEDBACK
TRANSMIT MESSAGE
E
RROR STATUS AND
FEEDBACK OUTPUT WITH
STAMPS
Feedback mode field
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0
Device Manual
field, select the baud rate for the CAN bus. If you select U
AN BAUDRATE
from the list, the entry field BTR (Bit Time Register) appears in the CAN
M field, check the F
ODE EEDBACK
Description
After transmission of a CAN message, a feedback message is
output via WLAN or Bluetooth.
If this function is enabled, every message transmitted by the CAN
bus is confirmed via the wireless Interface.
Error status and feedback messages are given a timestamp (not
possible if you have selected Off in the list in the T
field).
CANlink wireless
CAN
box to enable this
TRANSMIT MESSAGE
Operation
SER
M
IMESTAMP ODE
94