Operation As A Can-Can-Bluetooth Bridge; Configuring A Can-Can-Bluetooth Bridge - PROEMION CANlink wireless 3000 Series Device Manual

4.4 Operation as a CAN-CAN-Bluetooth Bridge

Use as a CAN-CAN-Bluetooth Bridge enables wireless transmission of CAN data between two
CAN bus systems. In this case, two CANlink wireless devices replace the CAN cable.
After switching on, a connection is automatically established between a configured master and
a slave device. Data is exchanged bidirectionally as soon as the connection between the two
devices has been established.
4.4.1

Configuring a CAN-CAN-Bluetooth Bridge

The device's factory-set configuration corresponds with the slave configuration. To be able to
use two devices as a CAN-CAN-Bluetooth Bridge, one must be configured as the slave and the
other as the master.
TIP
The Bluetooth MAC address of the slave device is required for master configuration. Start
with slave configuration.
INFORMATION
Save the configuration of your device before making alterations.
See chapter Saving the device configuration.
CONFIGURATION AS A CAN-CAN-BLUETOOTH BRIDGE SLAVE
1. Connect the device to the PC. See chapter Connecting the device with a PC via
2. Read out the device information from the CANlink wireless and save the current
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0
Device Manual
RS232.
configuration. See chapter Saving the device configuration.
CANlink wireless
Getting started
54