Reset Device (Repair Mode) - PROEMION CANlink wireless 3000 Series Device Manual

5.4 Reset device (repair mode)

Repair mode resets the device to factory settings.
1. Disconnect the device from the power supply.
2. At the RS232 Interface, Bridge TxD and RxD. For the connector assignment, see
3. Connect the power supply.
 The device is now in the "Repair mode ready" status. The LED flashes at a rate of
NOTICE
To cancel the reset, disconnect the power while the Bridge between TxD and RxD is active.
4. Remove the Bridge between TxD and RxD when the power supply is active.
 The device is in "Reset Status" and is reset to the factory settings. The LED flashes
 After the reset to factory settings, the device goes into sleep mode. The LED flashes
 The CAN bit rate is 250 kbit/s.
INFORMATION
For further information on the LED status signals, see chapter Indicator elements (LED).
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0
Device Manual
chapter RS232 connector.
500 ms.
green 3 times periodically in a cycle of 200 ms and a pause of 1000 ms.
green in a cycle of 200 ms.
CANlink wireless
Operation
113