Power Supply; Connecting The Device With A Pc Via Rs232 - PROEMION CANlink wireless 3000 Series Device Manual

4.2.4

Power supply

The device is supplied with power via the CAN connector.
INFORMATION
If, for test purposes or for a firmware update, you connect the device to a PC via a
communication gateway (e.g. CANview USB), the power is supplied by the power supply
unit via the
accessories.
4.2.5

Connecting the device with a PC via RS232

To connect the device with a PC for configuration purposes, you need the
pin/D-Sub/Power terminal 15 ON
for your country, and the
017) from the starter kit.
1. Install the USB driver pack and CANlink wireless Configurator from the PROEMION
2. Connect the device with the
3. Connect the device to the PC with the
Connecting the CANlink wireless 3002 to the PC
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0
Device Manual
CAN cable M12 5-pin/D-Sub/Power terminal 15
(part number 136 000 187), the power supply unit applicable
USB-RS232 converter cable, M12 5-pin, 1.8 m
Tools CD onto the PC. See chapter Installing software.
the power grid using the country-specific power supply unit from the starter kit.
1.8 m.
CANlink wireless
ON. See chapter Software and
CAN cable M12 5-pin/D-Sub/Power terminal 15 ON
USB-RS232 converter cable, M12-5-pin,
Getting started
CAN cable M12 5-
(part number 257 001
to
38