GE PanaFlow HT User Manual page 73

3.7.3c Setting the Frequency (cont.)
Note: If Other is selected, a screen similar to the following appears.
0
PanaFlow HT User's Manual
To change the current test frequency, press
the digital output to this value. Then verify at your measurement system that you
see the frequency you entered. You can repeat this procedure with several
frequencies.
To check the current error handling status, on the Frequency display select Err
Handling and press
To change the current error handling status, select the option desired and press
The screen returns to the previous display.You have four options for error
handling in case of a measurement error:
•
Hold — hold last good value.
•
Low —show 0 Hz.
•
High — show Full Frequency.
Enter the Hz value you want to appear for error. (For example, if Full = 1 kHz,
you may want to set
following appears.
Use the [] or [] arrow key to change the Other value and press
number. Press [
Hz

[ ]
. A screen similar to the following appears.
Error
to 2 kHz.) Press

]
to return to the previous screen.
Chapter 3. Initial Setup and Programming

[ ]
. Set a Hz value. The meter will set

[ ]
again, and a screen similar to the

[ ].

[ ]
to save the
63