Meter Setup - GE PanaFlow HT User Manual

3.6.3 Meter Setup

Note: The Meter Setup category is accessed by either the SIL User, Service or Factory passwords.
3.6.3a Zero Cutoff
0.500
PanaFlow HT User's Manual
To set up the meter, under User Preference, use the [] or [] arrow key to
select Meter Setup and press
Select Zero Cutoff, press
Note: Zero cutoff is based on velocity.
To set the zero cutoff, press
When the flow rate drops below the zero cutoff level, the flow will be forced to
0.00. This is to avoid measurement fluctuations near the zero point.
Use the[] and [] arrow keys to select each digit to be changed and the [] or
[] arrow keys to change the digit value, then press
to the Meter Setup screen.
Chapter 3. Initial Setup and Programming

[ ]
. The following screen appears.

[ ]
, and a screen similar to the following appears.

[ ]
and a screen similar to the following appears.
 
[ ] [ ] k
. Press the ey to return
47