Changing Measurement Type Or Value For Totalizer Screens - GE PanaFlow HT User Manual

3.4.3 Changing Measurement Type or Value for Totalizer Screens

The totalizer screen appears similar to Figure 24 below.
Totalizer Units
(See Section 3.5)
Totalizer
Measurement Type
Error Code
To change the number of decimal places in the value of a totalizer screen:
Total m^3
Fwd Batch
Rev Batch
E0
Total m^3
Fwd Batch 0.00
Rev Batch 0.00
E0
appropriate value. (Available options include 0, 1, 2, 3, 4, and Sci (Scientific
Notation). Press [  o select the value, and then [  ] again to confirm the selection or
] t

[ ] t
o cancel the selection.
PanaFlow HT User's Manual
Total m^3
Fwd Batch
Rev Batch
E0
Figure 24: The Totalizer Screen
From the display screen, press either the [] or [] buttons until the value is
highlighted
0.00
0.00
Once the value is highlighted, press
Use the [] and [] buttons to scroll to the
Chapter 3. Initial Setup and Programming
Start/Stop Totalizer
Reset Totalizer
0.00
Values
0.00

[ ] Display/Decimal
to open the option.
Display/Decimal
0
1
2
3
4
33