GE PanaFlow HT User Manual page 75

3.7.3 Digital Output C (cont.)
3.7.3d Setting the Alarm (cont.)
0
PanaFlow HT User's Manual
To check and/or change the type of alarm measure, select Measurement and

[ ]
press . A screen similar to the following appears.
Select the type of measure desired, press
previous display.
The Alarm Value is the threshold that trips the alarm. (This parameter does not
apply to Fault Alarms.) To check and/or change the alarm value, select Alarm

Value and press
[ ]
. A screen similar to the following appears.

[ ]
Press again, and a screen similar to the following appears.
Note: The units that appear will be the units selected in "Flow Units" on
page 43.
Use the [] or [] arrow key to change the Alarm Value setting. Press

the number and press [
Chapter 3. Initial Setup and Programming

[ ]
, and the screen returns to the
]
to return to the previous screen.

[ ]
to save
65