GE PanaFlow HT User Manual page 44

Chapter 3. Initial Setup and Programming
3.4.3 Changing Measurement Type or Value for Totalizer Screens (cont.)
To change the totalizer measurement type:
Total m^3
Fwd Batch 0.00
Rev Batch 0.00
E0
Total m^3
Fwd Batch 0.00
Rev Batch 0.00
E0
Display/Measurement Type
Forward Batch
Reverse Batch
Net Batch
Batch Time
Batch Time
If you select
the appropriate unit, from the highlighted measurement type, press the [] or [] buttons until the measurement unit is
highlighted.
Total m^3
Batch Time 0.00
Rev Batch 0.00
E0
Display/Unit
m^3
ft^3
GAL
MGAL
34
From the display screen, press either the [] or [] buttons until the measurement
type is highlighted.
Once the value is highlighted, press
The screen changes to
scroll to the appropriate parameter. Available parameters include: Forward Batch (Fwd
Batch), Reverse Batch (Rev Batch), Mass Batch and Batch Time. Once you have
chosen the type, press

[ ] t
selection or
, you can also select the time measurement units: seconds, minutes, hours or days. To choose
Once the unit is highlighted, press
Press the [] and [] buttons to scroll to the appropriate unit, and press
the unit, and then [  ] again to confirm the selection or
Note: If you have selected "Batch Time," the available units are seconds, minutes,
hours and days.

[ ]
Display/Measurement Type
 to select the value, and then [  ] again to confirm the
[ ]
o cancel the selection.

[ ] t
o open the
Display/Measurement Type
to open the
. Press the [] and [] buttons to
Display/Measurement Unit

[ ] t
o cancel the selection.
PanaFlow HT User's Manual
option.
option.

[ ] t
o select