Wiring Transducers (Remote Mount Cable) - GE PanaFlow HT User Manual

Chapter 2. Installation

2.6 Wiring Transducers (Remote Mount Cable)

For a PanaFlow HT remote mounting version, only the remote mount cable must be connected between the meter body
junction box and the XMT900 junction box. See Figure 17 below.
Transducer wiring to the meter body junction box and XMT900 electronics wiring to the XMT900 junction box is
completed at the factory. After installing the meter body and XMT900 electronics, you must wire the remote cable.
Before wiring the PanaFlow HT remote mount cable, complete the following steps:
•
Disconnect the main power from the XMT900 electronics enclosure.
•
Install required adapters on the enclosure.
22
Figure 17: Remote Cable Wiring
PanaFlow HT User's Manual