Remembering Data (Clipboard); Confirming An Error Message - TESTO 330 Instruction Manual

5 First steps
Only meas. views, which have a display field in the measurement
view assigned, will be saved / printed out.
To be able to transmit data via infrared or Bluetooth interface to a
protocol printer, the printer to be used must have been enabled,
see Enabling the printer:, page 37.
5.2.7.

Remembering data (clipboard)

With the help of the clipboard measuring results from various
measurement types can be combined to a common protocol, which
can then be printed out and saved (see above) Data are saved to
the clipboard via the menu
If there are data in the clipboard, the status bar shows the symbol
.
If there are data in the clipboard and the command
triggered, all data in the clipboard will be printed out or saved.
Only one set of measuring data can be recorded per measurement
type (e.g.
measurement type overwrites the previously saved data. When
changing the measurement place or the fuel, the clipboard is
deleted.
5.2.8.

Confirming an error message

If a failure occurs, an error message is shown in the display.
> Confirming an error message: [OK].
Failures which have occurred and have not yet been rectified are
indicated by a warning symbol (
Not yet rectified error messages can be displayed in the menu
Error
28
The measurement data can be printed out parallel to the
saving process, while a measurement program is running.
Flue Gas or Draft). Repetitive saving of test data of one
Diagnosis, see Instrument diagnosis, page 31.
Options and the command Clipboard.
) in the header.
Print or Save is