TESTO 330 Instruction Manual page 46

6 Using the product
> [Options]
as flue gas matrix, see below.
> [Options]
views per display page.
> [Options]
> [Options]
available during a measurement): The meas. view display menu
is opened.
Show flue gas matrix
This function is only available if the measurement parameter
has been enabled in the meas. view display.
Calling up the function:
✓ The flue gas function is opened.
> [Options]
Options
> [Options]
> [Options]
> [Options]
form of a line graph.
> [Options]
numerical values.
> [Options]
during a measurement) Set the system type to be able to
configure the ideal array (green) of the flue gas matrix, using
the limits pre-configured for each system type.
> [Options]
deleted.
> [Options]
measurement) Enter limits to be able to configure the ideal
array (green) of the flue gas matrix.
> [Options]
measurement parameter should be assigned to the x-axis of the
display matrix (O2 or CO2).
> [Options]
available during a measurement) Open the mesurement view
menu.
46
→ Flue Gas Matrix: The meas. views are displayed
→ Number of Lines: Change the number of meas.
→ Reset to Zero: The gas sensors are set to zero.
→ Meas. View Display: (This function is not
→ Flue Gas Matrix:
→ Clipboard: Data are saved to the clipboard:
→ Save: The meas. views are saved in a record.
→ Show Graphic: The meas. views are displayed in
→ Show Numerical
→ System Type: (This function is not available
→ Reset Graphic: The displayed graphical data are
→ Limits: (This function is not available during a
→ CO + O2 or CO +
→ Meas. View Display: (This function is not
Values: Data are displayed as
CO2: Choose which
CO