Configuring The Measurement View; Setting Location And Fuel; Flue Gas - TESTO 330 Instruction Manual

> Align the flue gas probe in the flue gas duct so that the tip is in
the hot spot (area of the highest flue gas temperature).
6.2.1.3.

Configuring the measurement view

Only those parameters and units which are enabled in the
measurement view appear in the measurement view, the saved
measurement protocols and the protocol printouts.
> Before performing measurements set up the measurement view
in such a way, that the required parameters and units are
enabled, see Measurement view, page 33.
6.2.1.4.

Setting location and fuel

Before carrying out measurements, the measurement location and
the fuel must be correctly selected, see Folders / measurement
places, page 29 and Fuels, page 41.
Pos: 62 /TD/Produkt verwenden/testo 330/testo 330 Abgasmessung @ 6\mod_1279108000429_7011.doc @ 65961 @
6.2.2.

Flue gas

Calling up the function:
1. [
2. Select the fuel → [OK].
Performing the measurement:
1. Start measurement:
- The meas. views are displayed.
2. Quit measurement:
Options
> [Options]
> [Options]
> [Options]
form of a line graph.
> [Options]
parameters to be represented (max. 4) can be displayed (
hidden (
] → Measurements
[
If a separate measurement of CO undiluted has not yet
been carried out, this value is calculated using the meas.
views of the flue gas probe and is updated continuously.
If CO undiluted has already been measured separately, the
value obtained is adopted.
[
→ Clipboard: Data are saved to the clipboard:
→ Save: The meas. views are saved in a record.
→ Show Graphic: The meas. views are displayed in
→ Configure
).
→ [OK] → Flue Gas
].
].
Graphic: The measurement
6 Using the product
→ [OK].
) or
45