Assigning Light Tower Outputs - Nordson ProBlue Flex Manual

System Settings
System I/O
Output
E 2020 Nordson Corporation

Assigning Light Tower Outputs

1. Select Output press > then select Light Tower.
2. Decide if you want to Invert (or reverse the polarity) of the Output. Select
ü
Invert and press to change the polarity. The default, is not inverted
(active high).
3. Use the Up key on the Navigation pad to select Assign, then press > to
view the output menu list selection. Use the Up/Down keys on the
Navigation pad to scroll through the list. Press
selection you want. When done, press < to return to the Light Tower
menu.
4. Decide if you want to test the current output assignment. Select Test,
ü
then press to toggle Start/Stop the test.
5. Press to return to the Home screen.
NOTES:
S
You can assign the same output selection to multiple outputs.
S
You can assign standard outputs using the Light Tower board.
S
The System Alert and System Fault outputs are inverted by default,
although the Invert check box is clear.
S
The default light tower output selections for the with the Legacy I/O
expansion kit are as follows:
‐
Output 1 through 7: Disabled
‐
Light Tower #2: System Fault
‐
Light Tower #3: Tank Low
S
The default light tower color associations are as follows:
‐
White - Power On/Off
‐
Green - System Ready
‐
Red - Any Fault Alarm or Flashing Red for any Stop Alarm
‐
Amber - Any Alert Alarm
‐
Blue - Idle condition (Setback, Heating, Pump Off, Ready Delay)
79
OLED User Interface
ü
to assign the output
Part 1128351_02