Defining Network Access; Setting Up Networking - Nordson ProBlue Flex Manual

86
OLED User Interface

Defining Network Access

System Settings
Networking
Part 1128351_02
The following section details how to connect this melter to your network, so
you can remotely monitor and change melter settings.
NOTE:
S
You must use a USB drive to upgrade/downgrade the melter
software/firmware, as well as to export all reports and logs.

Setting Up Networking

1. Select Public Wired Network, and press > to continue.
2. Decide if you want to use DHCP or not. Select DHCP and press
enable or disable this option. The default is Disabled.
3. Enter the following information to continue. Press the
pad to accept. When done, press the < button on the Navigation pad to
return to the Networking menu.
S
Default Gateway: Default is 192.168.3.1
S
Public IP: Default is 192.168.3.1
S
Public Subnet IP: Default is 255.255.255.0
Notes:
S
If you enable DHCP, the other networking settings disappear, as
they are not needed. If you are not using DHCP, continue to the
next step.
S
Changes to any IP address requires you to reboot the melter.
ü
to
ü
on the Navigation
E 2020 Nordson Corporation