Basic Operations; Additional Information - Nordson ProBlue Flex Manual

Basic Operations

Additional Information

E 2020 Nordson Corporation
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
The following is a list for accomplishing operator‐level tasks:
1. Filling the melter tank.
2. Starting the melter.
3. Monitoring and adjusting melter operation.
4. Shutting the melter down.
Before proceeding with the next set of tasks make sure the melter is fully
installed and connected as described in the accompanying Installation
Guide (P/N 1128353).
This section presents operating procedures in their most commonly used
form. Procedural variations or special considerations are explained in the
additional information table that follows most procedures. Where applicable,
some table entries also contain cross‐reference information. Additional
information tables are indicated by the symbol shown to the left.
13
OLED User Interface
Part 1128351_02