Figure 81. Removing the drive cage
Next steps
Replace the drive
cage.
Installing the drive cage
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the
drives.
4.
Remove the
backplane.
NOTE:
The procedure to install the drive cage is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Align the drive cage with the guide pins on the system and lower it until fully seated.
2. Using Phillips #2 screwdriver, tighten the blue thumbscrews.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
73