Removing Expansion Card From The Expansion Card Riser 1 - Dell PowerEdge XR12 Installation And Service Manual

Figure 42. Installing the expansion card riser 3
Next steps
1. Install the drive cage.
2. Install the backplane.
3. Install the drives.
4. Install the air shroud.
5. Install the expansion card riser
6. Follow the procedure listed in
7. Install any device drivers required for the card as described in the documentation for the card.

Removing expansion card from the expansion card riser 1

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card riser
4. Remove the air shroud.
5. Remove the expansion card riser
6. If applicable, disconnect the internal cables that are connected to expansion card.
NOTE: The procedure to remove the expansion card is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Pull and lift up the expansion card retention latch locks to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
46 Installing and removing system components
2.
After working inside your
Safety instructions.
Before working inside your
2.
1.
system.
system.