Table of Contents
Advertisement
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE:
Ensure that the processor and heat sink is held parallel to the system board to prevent damaging the
components.
Figure 100. Installing the processor and heat sink module (PHM)
3. Set the Anti-Tilt wires to the locked position (outward position), and then using the Torx #T30 screwdriver, tighten the
screws (8 in-lbs) on the heat sink in the order below:
a. Tighten the first screw completely.
b. Tighten the screw diagonally opposite to the screw you tighten first.
c. Repeat the procedure for the remaining two screws.
Installing and removing system components
91
Advertisement
Table of Contents
